Delta TP305 Instruction Manual page 13

4. Insert knife transfer tool (G) Fig. 21, underneath
center of knife. Lift the knife transfer tool up until
knife (H) separates from pins (J) and pull out and
remove knife as shown. NOTE: Knife transfer tool is
magnetized, allowing it to attach to knife.
5. Rotate knife (H) Fig. 22 end-for-end, or using a new
knife, position knife transfer tool (G) on top of knife
as shown. Place knife in cutterhead with bevel up
underneath locking bar (D), making sure pins (J) in
cutterhead engage with holes (K) in knife.
6. Remove knife transfer tool and tighten the six screws
at (F) Fig. 23, using wrench (E) supplied.
7. Replace other knife by rotating head 180 degrees and
repeat STEPS 3 THROUGH 6.
8. Slide cutterhead guard (B) Fig. 25 in as far as possible
and replace two knobs, one of which is shown at
(A) Fig. 25. These knobs were removed in STEP 2.
Fig. 21
G
Fig. 22
G
Fig. 23
F
Fig. 25
B
13
J
H
K
J
H
E
F
A
D