Output Patching; Changing Signal Path - Yamaha 01V96i Reference Manual

44
Input & Output Patching
3.
Press [ENTER] to confirm the change.
Tip:
• You can patch an input signal to multiple Input Channels.
• You can store the Input Patch settings to the Input Patch library.
Refer to "Libraries" on page 74 for more information.

Output Patching

The 01V96i's Stereo Out, Bus Out 1–8, Aux Out 1–8 signals
can be patched to any outputs, ADAT OUT output channels,
and slot output channels.
Patch example:
Output Patching
Aux Out 1
Aux Out 2
Aux Out 3
Aux Out 4
Aux Out 5
Aux Out 6
Aux Out 7
Aux Out 8
By default, the following signal paths are patched to outputs,
ADAT OUT output channels, and slot output channels:
Output connectors and slot channels
ADAT OUT output channels 1–8
Slot Channels 1–8
Slot Channels 9–16
OMNI OUT connectors 1–4
2TR OUT DIGITAL (L)
2TR OUT DIGITAL (R)
Tip:
• You can patch a signal to multiple outputs.
• You can store the Output Patch settings to the Output Patch
library. Refer to "Libraries" on page 74 for more information.
You can change these patches, if you desire. The procedure for
patching signals to output varies depending on the output
connectors and slots.
01V96i—Reference Manual
OMNI Out connector 1
OMNI Out connector 2
OMNI Out connector 3
OMNI Out connector 4
OMNI Out connector 1
OMNI Out connector 2
OMNI Out connector 3
OMNI Out connector 4
Signal flow
Bus Outs 1–8
Bus Outs 1–8
Bus Outs 1–8
Aux Outs 1–4
Stereo Out L
Stereo Out R
Changing the Signal Path to the
ADAT OUT Connector, Slot, or
OMNI OUT connectors
Follow the steps below to change the signal path patched to
the ADAT OUT connector, the optional mini-YGDAI card
installed in the slot, or the OMNI OUT connectors.
1.
Press the DISPLAY ACCESS [PATCH] button
repeatedly until the Patch | Out Patch page
appears.
Each parameter box displays the currently-patched signal
path.
1
2
3
1
SLOT 1–16
These parameter boxes set the routing of Slot Channel
1–16 signals.
2
ADAT 1–8
These parameter boxes set the routing of ADAT OUT
connector output channel 1–8 signals.
3
OMNI 1–4
These parameter boxes set the routing of OMNI OUT
connector 1–4 signals.
The parameter indicators are explained below:
Parameter value
–
BUS1–BUS8
AUX1–AUX8
ST L/R
INS CH1–INS CH32
INS BUS1–INS BUS8
INS AUX1–INS AUX8
INS ST-L/ST-R
CAS BUS1–BUS8
CAS AUX1–AUX8
CAS ST-L/ST-R
CASSOLOL/CASSOLOR Solo Bus Cascade Outs
2.
Move the cursor to a patch parameter you
wish to change, then rotate the Parameter
wheel or press the [INC]/[DEC] buttons to
modify the patching.
Description
No assignment
Bus Out 1–8 signal
Aux Out 1–8 signal
Stereo Out signal
Input Channel 1–32 Insert
Out
Bus Out 1–8 Insert Out
Aux Out 1–8 Insert Out
Stereo Out Insert Out
Bus 1–8 Cascade Outs
Aux Bus 1–8 Cascade Outs
Stereo Bus Cascade Outs