Attenuating Output Signals - Yamaha 01V96i Reference Manual

34
Bus Outs
2
F.S
This button determines whether Aux Sends follow the
Input Channel Surround Pan when the 01V96i is in any
Surround mode other than "Stereo. " When this button is
turned on, Aux Sends follow the Input Channel Surround
Pan. This is useful for feeding Surround signals to exter-
nal Surround effects processors.
2.
Move the cursor to the MONOx2 button for
the desired Bus or Aux Send, then press
[ENTER].
The buses or Aux Sends are paired.
3.
To cancel a pair, move the cursor to the STE-
REO button for the desired Bus or Aux Send,
then press [ENTER].
01V96i—Reference Manual
Attenuating Output
Signals
To attenuate the 01V96i's output signals, display the EQ | Out
Att page and adjust the Stereo Out and Bus Out 1–8 attenua-
tors individually.
If necessary, you can also select Output and I/O card channels
and specify the amount of attenuation. This technique is con-
venient when you want to attenuate output signals quickly,
regardless of the source signal patching.
1.
Press the DISPLAY ACCESS [DIO/SETUP] but-
ton repeatedly until the DIO/Setup | Output
Att page appears.
1
2.
Move the cursor in the left column (
scroll the list up or down using the Parameter
wheel to select the desired output or slot
channel for which you want to adjust attenu-
ation.
The following outputs and slot channels can be selected:
• STEREO OUT L/R ................ STEREO OUT L & R
• MONITOR OUT L/R............ MONITOR OUT L & R
• OMNI OUT 1–4 ..................... OMNI OUT connectors
• SLOT OUT 1–1 through 1–16
..................... Slot channels 1–16
• ADAT OUT 1–8 ..................... ADAT OUT channels 1–8
• 2TR OUT DIGITAL L/R...... 2TR OUT DIGITAL L & R
3.
Move the cursor to the parameter value in the
2
right column ( ), then rotate the Parameter
wheel or press the [INC]/[DEC] buttons to set
the amount of attenuation.
The amount of attenuation can be set from 0 dB to –9 dB.
Tip: To reset the attenuation amount of all Output Channels
to 0 dB, move the cursor to the INITIALIZE button, then
press [ENTER].
2
1
), then
channels
channels
1–4
channels