Viewing Aux Send Settings For Multiple Channels - Yamaha 01V96i Reference Manual

40
Aux Outs
Note:
• Do not raise the level of the Aux Sends (patched to the
effects processor) on the effects return channels.
• For example, by default, Aux 1 is routed to the input of the
internal Effects processor 1, and L and R of ST IN Channel
1 are patched to the processor's output. Under these con-
ditions, if you raise the level of the send signals from ST IN
Channel 1 to Aux 1, the signals are returned to ST IN
Channel 1, creating a signal loop and possibly damaging
your speakers.
01V96i—Reference Manual
Viewing Aux Send
Settings for Multiple
Channels
You can view and set parameters for all Aux Send 1–8, includ-
ing setting levels and Pre/Post parameters.
This is convenient when you wish to visually check all Aux
Send settings or simultaneously adjust the levels of certain
channels routed to Aux 1–8.
1.
Press one of the FADER MODE [AUX 1]–[AUX
8] buttons repeatedly until the page listed
below that contains the desired channels
appears.
• View1-16 page
This page displays the Aux Send levels of Input Channels
1–16.
• View17-STI page
This page displays the Aux Send levels of Input Channels
17–32 and ST IN Channels 1–4.
These pages display the source Input channels and the
corresponding Aux Sends in a matrix. The parameters on
these two pages (and the procedure for setting them) are
the same.
2
1
DISPLAY
Use the following buttons to display the desired parame-
ters.
• LEVEL......................Select the LEVEL button to display
Send level bar graphs for Input
Channels routed to Aux 1–8.
• PRE/POST ..............Select the PRE/POST button to dis-
play signal source points for Input
Channels routed to Aux 1–8.
2
FIX/VARI
These buttons indicate the Aux mode (Fixed or Variable)
for Aux Out 1–8 and are only for display purposes.
1
3