Yamaha 01V96i Reference Manual page 45

3.
Press [ENTER] to confirm the change.
Tip: You can store the Output Patch settings to the Output Patch
library. Refer to "Libraries" on page 74 for more information.
Patching the USB Outputs
By default, the following output signals are assigned to USB
OUT.
Outputs
USB OUT1–8 Bus Out 1–8 signals
USB OUT9–16 Bus Out 1–8 signals
If you want to change or verify this patching, proceed as fol-
lows.
1.
Press the DISPLAY ACCESS [PATCH] button
repeatedly until the Patch | USB Out page
appears.
The parameter boxes underneath each number indicate
the currently-assigned signal routing. The meaning of
these indicators are explained below.
Parameter value
–
BUS1–BUS8
AUX1–AUX8
ST L/R
INS CH1–INS CH32
INS BUS1–INS BUS8
INS AUX1–INS AUX8
INS ST-L/ST-R
2.
Move the cursor to a parameter box, and use
the Parameter wheel (or [INC]/[DEC]) to
modify the patching.
3.
Press [ENTER] to confirm the change.
Signals
Description
No assignment
Bus Out 1–8 signals
Aux Out 1–8 signals
Stereo Out signals
Input Channels 1–32 Insert
Outs
Bus Out 1–8 Insert Outs
Aux Out 1–8 Insert Outs
Stereo Out Insert Outs
Output Patching
Patching the 2TR Digital
Outputs
Follow the steps below to change the signal path patched to
the 2TR OUT DIGITAL connector.
1.
Press the DISPLAY ACCESS [PATCH] button
repeatedly until the Patch | 2TR Out page
appears.
Signals assigned on the Out Patch page can also be
assigned on this page.
2.
Move the cursor to a patch parameter you
wish to change, then rotate the Parameter
wheel or press the [INC]/[DEC] buttons to
modify the patching.
3.
Press [ENTER] to confirm the change.
45
01V96i—Reference Manual