Send To Aux Screen - Yamaha TF5 Reference Manual

PING PONG DELAY (V2.0 and later)
One-input, two-output ping pong delay. The delayed sound alternates between left and right
at equal intervals.
Parameter Range
Delay 1.0ms - 1350.0ms
Feedback Gain -99% - 99%
High Ratio 0.1 - 1.0
HPF Thru, 21.2Hz - 8.00kHz
LPF 50.0Hz - 16.0kHz, Thru
Sync Off, On
Note ----, -
DUAL PITCH (V2.0 and later)
Two-input, two-output pitch-shift effect.
Parameter Range
Pitch 1 -24 - 24
Fine 1 -50 - 50
Level 1 -100 - 100
Pan 1 L63 - R63
Delay 1 1.0ms - 1000.0ms
Feedback Gain 1 -99 - 99
Pitch 2 -24 - 24
Fine 2 -50 - 50
Level 2 -100 - 100
Pan 2 L63 - R63
Delay 2 1.0ms - 1000.0ms
Feedback Gain 2 -99 - 99
Mode 1 - 10
Sync Off, On
Note 1 ----, -
Note 2 ----, -
Description
Delay time.
Amount of feedback.
Amount of high-frequency feedback.
High-pass filter cutoff frequency.
Low-pass filter cutoff frequency.
Parameter tempo sync.
Value used to calculate the delay time based on the tempo.
Description
Pitch of Ch1 (semitone increments).
Pitch of Ch1 (1 cent increments).
Volume of Ch1.
Pan of Ch1.
Delay time of Ch1.
Feedback level of Ch1.
Pitch of Ch2 (semitone increments).
Pitch of Ch2 (1 cent increments).
Volume of Ch2.
Pan of Ch2.
Delay time of Ch2.
Feedback level of Ch2.
Width of pitch shift.
Parameter tempo sync.
Value used to calculate Delay 1 based on the tempo.
Value used to calculate Delay 2 based on the tempo.

SEND TO AUX screen

Allows you to configure the amount of signal that is sent from each channel to the AUX buses.
You can swipe left and right to view other buses.
1
Send button
Determines whether a signal is sent (on) or not sent (off) to the corresponding AUX bus.
2
Send level slider
Determines the amount of signal sent to the corresponding AUX bus.
- 57 -
Configuration screens
TF Series
Reference Manual