JVC BD-X200U - Dvd Authoring Recorder Instructions Manual page 15

8
RS-422A REMOTE terminal (D-sub 9-pin male)
This terminal is used to connect the DVD recorder to a VCR
capable of being controlled via RS-422A. RS-422A control of
a VCR using the RS-422A REMOTE terminal is carried out
with the DVD recorder operating in Master mode.
In order to use this terminal, set REMOTE SELECT from
the REMOTE MENU screen to 9PIN(MASTER).
Video and audio from the VCR can be recorded to a DVD
using commands issued from the REMOTE CONTROL
screen. (☞ Page 59)
9
LAN terminal (RJ-45)
When two DVD recorders are used to perform DVD-to-DVD
dubbing, this terminal is connected to both BD-X200s. A
cable of Category 5 or better is required for this connection.
A cross-type Ethernet cable is required when connecting
directly to another BD-X200.
This terminal is also used when connecting to a PC on
which BD-X200 utility software for operations such as the
creation of the title and chapter menus has been installed.
Network settings must be carried out using the NETWORK
MENU screen.
0
USB terminals (2)
These terminals are used when connecting the DVD recorder
to USB devices such as a keyboard or mouse.
A keyboard and mouse can be used as an alternative to the
DVD recorder's buttons when using setting and control
screens.
The input of text in setting screens is carried out using a
keyboard.
It is not be possible to operate devices other than a keyboard
or mouse by connecting them to the USB terminal.
Set KEYBOARD STYLE from the SYSTEM MENU screen
in accordance with the keyboard's input language.
Recommended manufacturers: Logitech
$
VIDEO
IN LINE OUT
Y/C
IN
DV IN/OUT
USB
LAN
SIGNAL
GND
9
# 0
!
DC IN terminal (2-pin)
This terminal is used to provide DC at 19 V to the DVD
recorder. The DC power cord from the AC adaptor (included)
should be connected here.
Note
When power is supplied via this terminal, the OPERATE
indicator on the front panel lights up in red.
@
DC power cord clamp
This clamp secures the DC power cord in place, and it should
always be used to prevent accidental disconnection.
#
SIGNAL GND terminal
This terminal is used to ground signals.
$
Optional-board slot cover
This cover is removed to allow commercially-available optional
boards to be installed.
AUDIO
INPUT CH1
LEVEL
IN OUT
4dB
8dB
CH2
REMOTE
8
DC 19V
!
@
13