Ricoh Priport HQ9000 Network Manual page 90

Appendix
Protocol
Use the "set" command to allow or prevent remote access for each protocol.
msh> set protocol {up | down}
Protocol
tcpip
appletalk
netware
smb
lpr
ftp
rsh
diprint
web
snmp
ipp
http
Note
❒ If you prohibit remote access via TCP/IP and then log out, you cannot use re-
mote access. If you did this by mistake, you can use the control panel to allow
access by TCP/IP.
❒ When you prevent access via TCP/IP, you are also prevented from using lpr,
ftp, rsh, diprint, web, snmp, ipp, and http.
❖ Display
The following command displays current tcpip, appletalk, netware, and smb
settings.
9
msh> set protocol
84
"up" means active and "down" means inactive.