Ricoh Priport HQ9000 Network Manual page 89

❖ Access control initialization
msh> access flush
Note
❒ This restores the factory default so all access ranges become "0.0.0.0".
DHCP
Use the "dhcp" command to configure the DHCP settings.
❖ Reference
The following command displays the current DHCP settings.
msh> dhcp
❖ Configuration
You can configure the DHCP settings.
msh> dhcp interface_name [on | off]
Note
❒ Select [on] to enable DHCP. Select [off] to disable DHCP.
❖ Interface Priority Configuration
You can assign priorities governing which interface obtains DHCP parame-
ters.
msh> dhcp priority interface_name
Note
❒ Priority assignment is useful when connecting more than one interface to the
printer.
❒ If an interface is not selected, it appears according to the currently set priority
regardless of multiple interface connections.
Interface name
ether
*1
wlan
*1
Available when the IEEE 802.11b interface unit is installed.
Reference
For more information about DHCP, see p.100 "Using DHCP".
Interface to be configured
Ethernet interface
IEEE 802.11b interface
Remote Maintenance by telnet
9
83