General - Dell PRECISION 610 User Manual

NOTE: You must install Windows NT 4.0 Service Pack 3 and the Microsoft updated
ATAPI driver before installing the NIC drivers. Otherwise, the integrated NIC will not
function properly.
See the Dell Microsoft Windows NT Workstation 4.0 Setup Guide for general installa-
tion information for Windows NT 4.0 and for information about other drivers or
supplements that may be required. For installation instructions for the various drivers,
see the appropriate section or document as follows:
Windows NT 4.0 SCSI controller drivers — See "SCSI Drivers for
Windows NT 4.0" in Chapter 7 .
Windows NT 4.0 Microsoft updated ATAPI driver — See "Microsoft Updated
ATAPI Drivers" in Chapter 2.
Windows NT 4.0 video drivers — See the documentation for your graphics
adapter.
Windows NT 4.0 NIC driver — See "Windows NT 4.0 NIC Driver" in Chapter 5.
Windows NT 4.0 audio drivers — See "Audio Drivers for Windows NT 4.0" in
Chapter 6.
After you have completed the setup procedure for the Dell-installed Microsoft
Windows NT 4.0 operating system, you can perform the following procedure to cre-
ate disk partitions on your large-capacity hard-disk drive(s):
Follow the instructions in the Disk Administrator utility to partition and format
your drives.
The computer's front panel contains the following indicators and controls (see
Figure 1-1):
The power button provides control of the system's alternating current (AC) input
power. The push-button switch operates as follows:
— When the computer is turned off, pressing the button turns the computer on.
— When the computer is turned on, pressing the button turns the computer off.
However, a low-voltage (standby) current is maintained by the power supply.
Introduction 1-7