68-pin SCSI cable
(to hard-disk drive)
)LJXUH ,QWHUQDO 6&6, &DEOH
Configure and install one or more SCSI devices in your computer as follows:
See "SCSI Configuration Guidelines" found earlier in this section.
Configure the device for a SCSI ID number and disable termination, if necessary.
For instructions, see the documentation that came with the SCSI device as well
as "SCSI Configuration Guidelines" found earlier in this section.
To install a SCSI hard-disk drive , complete steps 3 through 9 of "Installing an
EIDE Hard-Disk Drive in the Internal Hard-Disk Drive Cage" found earlier in
this chapter. Then continue with step 4 of this procedure.
To install a SCSI tape drive, CD-ROM drive , or DAT drive , complete steps 2
through 6 of "Installing a Drive in a 5.25-Inch Drive Bay" found earlier in this
chapter. Then continue with step 4 of this procedure.
To install an external SCSI device , continue with step 4 of this procedure.
50-pin SCSI cable
(to device[s] in externally
accessible drive bay)
Installing Drives 10-19