Dell PRECISION 610 User Manual page 109

If the expansion card is full-length, insert the front end of the card into the corre-
sponding card guide on the inside front of the chassis as you insert the card into
its connector.
Insert the card's edge connector firmly into the expansion-card slot. Gently rock
the card into the connector until it is fully seated (see Figure 9-4).
expansion card
)LJXUH  ,QVWDOOLQJ DQ ([SDQVLRQ &DUG
See the documentation that came with the card for information about the card's
cable connections.
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
See Chapter 3, "Using the System Setup Program," for instructions.
NOTE: If a setup password has been assigned by someone else, contact your
network administrator for information on resetting the chassis intrusion detector.
expansion-card
connector
Installing System Board Options
card-edge
connector
9-5