Modifying A Card; Removing A Card - Dell PRECISION 610 User Manual

The ICU detects
a resource conflict
between this card and
conflicting_card .The con-
flicting resource was:
resource.
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary.
C-4 Dell Precision 610 Mini Tower Systems User's Guide
FRQWLQXHG
You added or modified a
card that now requires a
resource value
already in use by
conflicting_card .
Try each of the following options until
the problem is resolved:
Modify the card you are adding so
that it uses a different value for
resource . See "Modifying a Card"
in Chapter 4 for instructions.
Modify conflicting_card so
that it uses a different value for
resource . See "Modifying a Card"
in Chapter 4 for instructions.
If conflicting_card is not the
system board or riser board,
remove it from the computer. See
"Removing a Card" in Chapter 4
for instructions.
Remove all expansion cards from
the ICU, and then add them back
one at a time, beginning with the
new card and resolving resource
conflicts as they arise. See
"Removing a Card" and "Adding a
Listed Card" or "Adding an
Unlisted Card" in Chapter 4 for
instructions.
If you cannot resolve the resource
conflict by any of the preceding
methods, remove the new card. If
you were modifying an existing
card, reset the modified card to its
previous resource value.