BMW R 1200 C Repair Manual page 249

•
Detach the brake hose holder
•
Press off the left swinging arm bearing cap.
e
Caution:
When installing, check that O-ring is in good condi-
tion.
•
Loosen the left swinging arm bearing.
•
Loosen screws for right swinging arm bearing.
00 8 582
•
Using pull rod, BMW No. 00 8 581, and impact
weight, BMW No. 00 8 582, pull out the swinging
arm bearing.
•
Remove the left swinging arm bearing.
•
Remove rear swinging fork.
•
Remove rubber sleeves for intake air pipes.
•
Pull brake fluid reservoir out of holder.
•
Remove the holder.
•
Detach the right plug retaining plate.
•
Pull off the air temperature plug.
•
Detach the gear lever.
•
Separate the throttle potentiometer and throttle
positioner plugs at the left plug retaining plate.
•
Detach both fuse boxes at the plug retaining
plate.
•
Separate the side (prop) stand switch plug.
•
Separate the neutral indicator switch plug.
•
Detach the left plug retaining plate.
•
Remove the injectors.
•
Pull off the injector line plugs.
•
Detach the breather hose at the air cleaner cas-
ing.
•
Disconnect the brake light switch plug and de-
tach the cable.
•
Detach the air cleaner casing.
•
Remove rear section of frame.
•
•
X
Rear section of frame to engine
Pin ............................................................... 58 Nm
M10 bolt....................................................... 41 Nm
Rear section of frame to gearbox ................. 71 Nm
C330030
00 8 581
C330040
Remove fittings.
Install by following the above work instructions in
the reverse order.
Tightening torque:
46.9