•
Drain fluid from brake system.
e
Caution:
Do not allow brake fluid to come into contact with
painted parts of the motorcycle, because brake fluid
destroys paint.
•
Remove fuel tank.
•
Remove brake lines.
•
Install by following the above work instructions in
the reverse order.
e
Caution:
Renew sealing rings for brake line.
Attach brake line to master cylinder so that it cannot
become kinked or abraded when the handlebar is
turned.
Fill/bleed the brake system.
X
Tightening torque:
Brake hose and brake line............................ 15 Nm
Bleed screws in front brake caliper ................ 7 Nm
Bleed screw on rear brake caliper .................. 4 Nm
Bleed screw on ABS unit................................ 9 Nm
Junction block at front frame.......................... 9 Nm
Junction block to slider tube .......................... 9 Nm
34.22