Height Of Suspension - BMW HP2 SPORT Rider's Manual

If you want to increase
compression-stage damping,
turn knob 1 in direction H.
If you want to reduce
compression-stage damping,
turn knob 1 in direction S.
Compression stage, basic
setting, rear
Adjust damping by turning
top knob to fully tightened
position, then back it off 14
clicks. (Motorcycle with full
load of fuel, with rider 85 kg)

Height of suspension

Setting
You can vary the height of the
suspension. You do this by
changing the position of the front
forks in the bottom fork bridge
and adjusting the length of the
spring strut.
Adjusting height of front
forks
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Remove screw 1 on left and
right.
While supporting the engine
spoiler, remove screw 2 on left
and right.
Push the engine spoiler slightly
to the rear and work it down to
remove.
5
77
z