Adding A Floppy Drive - Dell MTC2 User Manual

Secure the filler bracket onto the end of the card with the screw you removed in step 7.
9
Connect any cables that should be attached to the card.
10
See the documentation for the card for information about the card's cable
connections.
NOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can
cause damage to the equipment.
Replace the computer cover (see page 96).
11
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then
plug it into the computer.
Connect your computer and devices to electrical outlets, and turn them on.
12
Install any drivers required for the card as described in the card documentation.
13

Adding a Floppy Drive

CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions on page 9.
Shut down the computer through the Start menu (see page 28).
1
Ensure that your computer and attached devices are turned off. If your computer and
2
attached devices did not automatically turn off when you shut down your computer,
turn them off now.
NOTICE: To disconnect a network cable, first unplug the cable from your computer and then
unplug it from the network wall jack.
Disconnect any telephone or telecommunication lines from the computer.
3
Disconnect your computer and all attached devices from their electrical outlets, and
4
then press the power button to ground the system board.
CAUTION: To guard against electrical shock, always unplug your computer from
the electrical outlet before opening the cover.
Remove the computer cover (see page 76).
5
Release and remove the front panel:
6
a
b
82
Re m ov i n g a n d I ns t al l i n g Pa r t s
Push the release lever to release the top tab.
Reach inside the computer and push the bottom tab towards you to release it (the
middle tab releases automatically).