Table of Contents
Advertisement
Parallel Printer
You can connect a standard parallel printer to your system unit. To install
the printer, you need the printer drivers and a printer cable. Use a cable
with a male 25-pin connector for connecting to the parallel port on the
back of the system unit and a Centronics
on the other end for connecting to the printer.
Refer to your printer documentation for details on installing the printer,
including driver installation and cabling instructions.
External Monitor
You can add a standard Plug and Play external monitor or projector to
your system unit. The VGA connector on the back of the system unit
supports any size NEC MultiSync
or other VGA-compatible monitor with a 15-pin connector.
To install the monitor or projector, you need a power cable and a signal
cable (both are usually supplied with the unit). The signal cable must have
a 15-pin cable connector for connecting to the system unit.
Power down the system and connect the signal cable to the VGA port on
the back of the system unit and the power cable to a grounded wall outlet.
Turn on the monitor or projector and power up the system unit. On power
up, the system unit automatically shuts off the LCD panel and switches to
the external monitor or projector.
See your monitor or projector documentation for details on installing,
setting up, and adjusting the unit.
Serial Devices
You can add external Plug and Play serial devices such as an external
modem or a printer to your system unit. Connect the device to the serial
port on the back of the system unit.
To install the device, you need the device drivers and a serial cable with a
female 9-pin connector.
5-12 Adding Expansion Devices
®
-compatible 36-pin connector
®
monitor, NEC VistaScan™ monitor,
Advertisement
Table of Contents
