Table 1: Supported Sfp Transceivers - SMC Networks SMCGS10C-SMART Installation Manual

network connections to PCs or servers, or to other switches or hubs. (See
"1000BASE-T Cable Requirements" on page
Each of these ports support auto-negotiation, so the optimum transmission
mode (half or full duplex), and data rate (10, 100, or 1000 Mbps) can be
selected automatically. If a device connected to one of these ports does not
support auto-negotiation, the communication mode of that port can be
configured manually.
Each port also supports IEEE 802.3x auto-negotiation of flow control, so the
switch can automatically prevent port buffers from becoming saturated.
SFP T
RANSCIEVER
The Small Form Factor Pluggable (SFP) transceiver slots are independent ports.
The following table shows a list of transceiver types that have been tested with
the switch. For an updated list of vendors supplying these transceivers, contact
your local dealer. For information on the recommended standards for fiber optic
cabling, see "Fiber Optic SFP Devices" on page

Table 1: Supported SFP Transceivers

Media Standard Fiber Diameter (microns) Wavelength (nm) Maximum Distance
1000BASE-SX
1000BASE-LX
1000BASE-LH
100BASE-FX
1000BASE-T
* Maximum distance may vary for different SFP vendors.
S
LOTS
50/125
62.5/125
50/125
62.5/125
9/125
9/125
50/125 or 62.5/125
9/125
47.)
45.
850
850
1300
1300
1300
1310
1550
1300
1300
– 24 –
| Introduction
C 1
HAPTER
700 m
400 m
550 m
550 m
10 km
35 km
80 km
2 km
20 km
100 m
Overview
*