Table 3: System Status Leds; Figure 4: Power Supply Inlet - SMC Networks SMCGS10C-SMART Installation Manual

Table 3: System Status LEDs

LED
Power
Diag
P S
OWER UPPLY
There is one power inlet on the rear panel of the switch. The standard power
inlet is for the AC power cord.

Figure 4: Power Supply Inlet

G P
ROUNDING OINT
To prevent accidental electrical shock or damage to your switch, it is
recommended that you ground the switch to an earth point by attaching a
grounding wire (not supplied) to the grounding point located on the rear panel,
with a metal screw. If located in a tall building, grounding points include metal
drain pipes, and other electrostatic conductive devices that lead to the ground,
or if located on the first floor of a building, the ground outside itself.
Condition Status
On Green The unit's internal power supply is operating normally.
Off The unit has no power connected.
On Green The system diagnostic test has completed successfully.
Flashing The system boot up is in progress.
Green
On Amber / The system diagnostic test is in progress.
Flashing
Amber
Off The system diagnostic has completed.
I
NLET
– 26 –
| Introduction
C 1
HAPTER
115-240Vac, 50-60Hz, 0.5A
Power Supply Inlet
Overview