Table of Contents
Advertisement
C
ONFIGURING THE
Web – Click SNMP, Configuration. Enter the IP address and community
string for each management station that will receive trap messages, specify
the UDP port, SNMP version, trap security level (for v3 clients), trap
inform settings (for v2c/v3 clients), and then click Add. Select the trap
types required using the check boxes for Authentication and Link-up/
down traps, and then click Apply.
CLI – This example adds a trap manager and enables authentication traps.
Console(config)#snmp-server host 10.1.19.23 private version 2c
udp-port 162
Console(config)#snmp-server enable traps authentication
Configuring SNMPv3 Management Access
To configure SNMPv3 management access to the switch, follow these
steps:
1. If you want to change the default engine ID, do so before configuring
other SNMP parameters.
2. Specify read and write access views for the switch MIB tree.
3-58
S
WITCH
Figure 3-25 Configuring SNMP Trap Managers
4-155
4-158
Advertisement
Table of Contents
