Table of Contents
Advertisement
C
L
OMMAND
INE
lacp system-priority
This command configures a port's LACP system priority. Use the no form
to restore the default setting.
Syntax
lacp {actor | partner} system-priority priority
no lacp {actor | partner} system-priority
•
•
•
Default Setting
32768
Command Mode
Interface Configuration (Ethernet Ports 1-8)
Command Usage
• Port must be configured with the same system priority to join the same
LAG.
• System priority is combined with the switch's MAC address to form the
LAG identifier. This identifier is used to indicate a specific LAG during
LACP negotiations with other systems.
• Once the remote side of a link has been established, LACP operational
settings are already in use on that side. Configuring LACP settings for
the partner only applies to its administrative state, not its operational
state, and will only take effect the next time an aggregate link is
established with the partner.
Example
Console(config)#interface ethernet 1/5
Console(config-if)#lacp actor system-priority 3
Console(config-if)#
4-190
I
NTERFACE
actor - The local side an aggregate link.
partner - The remote side of an aggregate link.
priority - This priority is used to determine link aggregation group
(LAG) membership, and to identify this device to other switches
during LAG negotiations. (Range: 0-65535)
Advertisement
Table of Contents
