Configure The Remote Site; In-Band Connections; Telnet Connection - SMC Networks 8606SX - annexe 1 Management Manual

Configure the Remote Site

At the remote site, connect the PC's COM port (COM 1~4) to the
modem's serial port. Set terminal emulation type to VT100, specify
the port used by your PC (i.e., COM 1~4), and then set
communications to 8 data bits, 1 stop bit, no parity, 19200 bps and
no flow control.

In-Band Connections

Prior to accessing the management agent via a network
connection, you must first configure it with a valid IP address,
subnet mask, and default gateway using an out-of-band
connection or the BOOTP protocol.
Note: By default BOOTP is disabled. To enable BOOTP, see "IP
Configuration" on page 2-11.

Telnet Connection

Prior to accessing the management agent via an in-band Telnet
connection, you must first configure it with a valid IP address,
subnet mask, and default gateway using an out-of-band
connection or BOOTP protocol. After configuring the switch's IP
parameters, you can access the on-board configuration program
from anywhere within the attached network.
Note: Use the Network Configuration menu to specify the
maximum number of simultaneous Telnet sessions that are
supported by the system (up to four).
S M
W ITCH A NAGEMEN T
1-3