Replacing The Smartcard Assembly - Dell LATITUDE E6400 XFR Service Manual

8. Left up on the back edge of the smartcard assembly and rotate the left edge toward the back. Continue until
the smartcard assembly is free from the base assembly.
9. Lift up to remove the smartcard housing from the base assembly.

24.2 Replacing the Smartcard Assembly

1. Set the smartcard assembly in place by aligning the rectangle openings with the tabs on the base assembly.
2. Follow the figure above for inseting the smartcard assembly into the base assembly
3. Replace and tighten the two M2.5 x 5-mm screws.
4. Replace and tighten the three M2x3 mm screws.
5. Reconnect the smartcard flex cable to the system board.
6. Remove the tape backing from the smartcard gasket and adhere to the chamber ceiling.
NOTICE: If improperly installed, the Smartcard gasket may not allow a card to be inserted or
removed from the smartcard reader. ALWAYS test insertion and removal after replacement.
Page 48
™
Dell Latitude™ E6420 XFR Service Manual