Replacing The Display Bezel; Lcd Panel; Removing The Lcd Panel - Dell LATITUDE E6400 XFR Service Manual

15.2 Replacing the Display Bezel

CAUTION: Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
1. Place the Display Bezel on the Display Assembly.
2. Replace and tighten the 18 M2.5 x 8 mm secrews to secure the bezel to the Display Assembly.
3. Place the right and left antenna covers on the Display Assembly.
4. Replace and tighten the 5 M2.5x8 mm screws to secure each antenna cover to the Display Assembly.
5. Close the Display Assembly.
6. Replace and tighten the 4 M2.5x8 mm screws on the Display back.

16 LCD Panel

16.1 Removing the LCD Panel

CAUTION: Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
1. Follow the procedures in Before Working on Your Computer.
2. Remove the display bezel (see Removing the Display Bezel).
3. Using a plastic scribe at the top edge of the LCD Panel, gently lever the top edge of the LCD panel out of the
Display Back.
4. Pull the LCD panel completely out of the Display back and lay screen down on top of the base assembly. The
LCD Panel is connected to the system through an LVDS connection located on the back of the panel.
Page 34
™
Dell Latitude™ E6420 XFR Service Manual