Wlan/Wimax Card; Removing The Wlan/Wimax Card - Dell LATITUDE E6400 XFR Service Manual

1. Tighten the single captive screw highlighted in the figure abovve
2. Replace and tighten the twenty-three M2.5 x 5-mm screws in the sequence identified in the figure above.
3. Follow the procedures in After Working on Your Computer.
3

WLAN/WiMax Card

CAUTION: Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
NOTICE: Insert a WLAN or WiMax card only into the slot labeled WLAN/WiMax.

3.1 Removing the WLAN/WiMax Card

1. Follow the procedures in Before Working on Your Computer.
2. Remove the Bottom Access Panel (see Removing the Bottom Access Panel).
Page 10
™
Dell Latitude™ E6420 XFR Service Manual
Battery release latches in locked position
1
1 WLAN/WiMax Card 2 M2x3 mm (1)
2