Microphone/Camera Module (Optional); Removing The Microphone/Camera Module; Replacing The Microphone/Camera Module - Dell LATITUDE E6400 XFR Service Manual

4. Position the two upper corner dampners on the LCD panel (top edge) before the LCD panel is installed in the
display back.
5. Rotate the panel up and position the lower edge into the corner dampners in the Display Back. Continue to
rotate the LCD panel into position and insure the upper corner dampners are correctly located on each corner
of the LCD panel, between the LCD panel and the Display Back.
6. Replace the display bezel(see Replacing the Display Bezel).
7. Follow the procedures in (After Working On Your Computer).

17 Microphone/Camera Module (Optional)

17.1 Removing the Microphone/Camera Module

CAUTION: Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
1. Follow the procedures in Before Working on Your Computer.
2. Remove the display bezel (see Removing the Display Bezel).
3. Loosen the captive screw on the right side that secures the Microphone/Camera module to the Display Back.
4. Lift out Microphone/Camera Module from right side and disconnect the flex cable identified in the figure below.
5. Remove the Microphone/Camera Module

17.2 Replacing the Microphone/Camera Module

1. Install the Microphone/Camera Module into the Display Back.
Page 36
™
Dell Latitude™ E6420 XFR Service Manual
1 Flex Connection 2
3 M2x3 mm (1)
Microphone/Camera Module