Camera/Microphone Module; Removing The Camera; Installing The Camera - Dell P137G Service Manual

Camera/microphone module

Removing the camera

Prerequisites
1. Follow the procedure in
2. Enter Service Mode.
3. Remove the SIM card.
4. Remove the microSD
5. Remove the base cover.
6. Remove the display assembly.
7. Remove the display bezel.
8. Remove the display panel.
9. Remove the display hinges.
About this task
The following images indicate the location of the camera module and provide a visual representation of the removal procedure.
Steps
1. Peel the tape that secures the camera cable.
NOTE: An abrupt peeling may also remove the camera shutter from the display bezel and damage the camera shutter.
2. Lift the latch and disconnect the camera cable from the connector on the camera module.
3. Carefully pry up the camera module starting from the prying point at the bottom edge of the camera module.
4. Carefully lift the camera module from the display back cover.

Installing the camera

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
84 Removing and installing components
Before working inside your
card.
computer.