VDO MS 3200 Owner's Manual page 19

MOUNTING INSTRUCTIONS
Initial start-up
1. Reconnect the car battery.
2. Restore perfect functioning of the electrical system (clock, onboard computer, alarm
system, air bag, immobilizer, radio coding, etc.).
3. Switch on the ignition.
4. Insert map CD into the navigation computer. Please note the instructions regarding
activation of C-IQ map, travel and/or traffic info, see the operating instructions,
Section "C-IQ INTELLIGENT CONTENT ON DEMAND" on page 20.
5. Insert batteries (not supplied) in the battery compartment of the remote control (see
user manual of the navigation system).
If an RCD 3200 active holder (accessory) is used for the remote control, the remote
control also works without batteries when placed in the holder.
6. Park the car so that the GPS antenna has free "visual contact" to the sky.
7. Start the engine.
The monitor display appears (user advice).
8. Confirm the user advice by pressing OK key on the remote control.
The start menu appears, initialization of the navigation computer then begins
(duration between 2 and 10 minutes).
Setting mounting angle
In order to ensure perfect functioning of the system, the computer must be adjusted
to the actual installation angle (e.g., in the dashboard).
1. Select the "
2. Depending upon the installation, set the angle to between - 10 and + 30 degrees.
The system does not differentiate between negative and positive angles. Thus, even
for a mounting angle of, e.g. - 10 degrees, set a value of "10" in the menu.
Checking the car functions
A
Only check safety functions when the car is standing still or driving at low speed!
Always carry out checks in open areas!
Check brake system, alarm system, lights, immobilizer, speedometer, trip computer,
radio (coding) and hi-fi stereo, clock.
Checking the navigation functions
Check the following functions when the car is stationary:
Remote control (batteries inserted)
Press the keys on the remote control and check operation.
GPS reception
Enter a destination and select "
menu via the guidance screen (see operating instructions) and check the number of
satellites. For a sufficiently exact location determination the number should be
between 4 and 8.
14
" option from the "
". Call up the "
" menu.
" information