Switching On / Off; Stand-By Mode; Volume - VDO MS 3200 Owner's Manual

OPERATION
Active remote control holder RCD 3200 (optional accessory)
If you use your remote control in the optional holder RCD 3200, the internal batteries
are not used.
When the batteries are exhausted the navigation system may no longer react on key
presses.
Slide the remote control into its holder to resume normal operation.
Replace the batteries. Battery replacement see page 54.

Switching on / off

The navigation system is switched on / off together with the ignition.
Switch on the ignition.
:
As soon as the navigation system is operable, an advice on the use of the system
appears on the display.
Read and confirm this advice by pressing OK on the remote control.
:
The "
After a few seconds the system is initialized and you can select the navigation
functions (options in highlighted letters).

Stand-by mode

You can switch the system to its stand-by mode as follows:
Select "
:
The display is switched off and audible guidance advice is muted.
Press one of the cursor keys 4, 6, 8, 2 or the OK key on the remote control to
resume normal operation.
If the navigation system was switched off in stand-by mode, it restarts in stand-by
mode when turning the ignition on again.

Volume

You can adjust the volume of the audible guidance advice as follows:
Press the + key once or more than once to increase the volume of the voice
messages.
Press the - key once or more than once to decrease the volume of the voice
messages.
:
The adjusted volume is announced.
The volume can be set so that the volume is increased depending on the driving
speed. See "System Settings", page 51.
24
" menu appears.
" from the main control menu.