Mounting Instructions - VDO MS 3200 Owner's Manual

IMPORTANT NOTES
A
Installation may only be carried out by trained specialists!
A
Observe all quality standards of the automobile industry!
A
Fire hazard! When drilling pay attention to the location of cable harnesses, tank and
fuel pipes!
A
Never drill into car parts which are load bearing or are important for safety reasons!
When installing components in the interior of the car remember the following:
A
The driver's field of vision must not be obstructed!
A
Increased risk of injury in accidents! Do not mount components in an area where the air
bag will inflate or where head or knees could impact in the event of an accident!
A
Installation may only be made in vehicles with 12 V board voltage and negative pole on
car body. Installation in unsuitable vehicles could result in malfunction, damage or fire!
Checking the scope of delivery, ill. 1
1 Navigation computer with mounting sleeve and 2 mounting hooks
2 Monitor, monitor connector with cable, monitor holder with mounting plate,
double-sided self-adhesive tape and 4 screws
3 IR remote control with holder
4 Signal cable
5 Power supply cable
6 GPS antenna with metal plate and cable
7 Mounting brackets and installation material
8 Language Loading Software CD
9 Instructions for use and mounting instructions
Take safety precautions
A
Before starting work disconnect the negative car battery terminal! When doing so
make sure to observe manufacturer's safety instructions (alarm system, air bag,
immobilizer, radio coding, etc.)!

MOUNTING INSTRUCTIONS

9