VDO MS 3200 Owner's Manual page 18

Connecting system components (ISO connector B)
Remote control holder RCD 3200 (accessory):
Connect the Mini DIN plug of the remote control cable to the socket on the signal
cable harness 4.
Loudspeaker (accessory):
Connect the loudspeaker (optional accessory ML 5000) with the 3.5 mm jack to the
3.5 mm plug of the signal cable harness 4.
The loudspeaker impedance should be between 4 and 8 Ohms.
Installing loudspeaker mute function (optional)
Connect the white/brown cable (B4) of the signal cable 4 to the mute input of the car
radio.
TMC extension (ISO connector C2):
For system enhancement, an optional VDO Dayton TMC receiver can be connected to
the navigation computer. For connection details see "Mounting the navigation
computer".
Hands-free unit (ISO connector C1):
A VDO Dayton hands-free unit can additionally be connected to the navigation
computer. For connection details see "Owner's manual and mounting instructions
MG 3000 M".
Reproduction of voice messages through vehicle speakers
For reproduction of the guidance messages by the left front speaker of the vehicle you
can connect an adaptor cable MA 1300 (optional) between the loudspeaker connector
and the audio output of the navigation computer.
Mounting the navigation computer
1. Connect the GPS antenna.
2. Connect power supply cable 5 to ISO connector A' at the navigation computer.
3. Connect signal cable 4 to ISO connector B' at the navigation computer.
4. Insert yellow plug C1 of the monitor cable into the left chamber of ISO connector C1'
at the navigation computer.
5. If you want to connect system extensions, take care to slide all the C plugs together
before connecting them to ISO connector C' at the navigation connector.
Green plug C2 of the TMC extension (optional): middle part (C2) of ISO connector C2'
6. Screw the rubber buffer onto the rear support stud of the navigation computer and
slide the computer into the metal sleeve until it clicks into position.
Caution: First mount the navigation computer firmly, then make the connection to
the vehicle's power supply. Otherwise a wrong calibration of the gyro sensor may
result.
MOUNTING INSTRUCTIONS
13