Kick Start - APRILIA HABANA 125 - PART2 Manual

CAUTION
Avoid pressing the start push button
" " (6) when the engine is running,
since you may damage the starter.
N
If the engine does not start in three or four
seconds, slightly rotate the throttle grip
(7) (Pos. A), keeping the start push but-
ton " " (6) pressed.
CAUTION
As soon as the engine has started, the
engine oil pressure warning light "
must go out.
If this does not occurr, or if the warning
light comes on while the engine is run-
ning, this means that the pressure in
the circuit is insufficient.
In this case, stop the engine immediate-
ly and contact an Official Dealer.
Do not use the vehicle with insufficient
engine oil, in order to avoid damaging
the engine components.
N
Do not accelerate and pull the brake le-
vers at the same time until you move off.
To leave, see p. 37 (DEPARTURE AND
DRIVE).

KICK START

For the kick start, proceed as follows:
N
Position the vehicle on the centre stand.
N
Move to the left side of the vehicle.
"
N
Make sure that the light switch (1) is in
position" • ".
N
Make sure that the dimmer switch (2) is
in position " ".
N
Turn the ignition switch (3) to position
" ".
N
Move the engine stop switch (4) to posi-
tion " ", (in the countries where re-
quired).
N
To avoid losing control of the vehicle dur-
ing the starting, lock both wheels by
putting on the brake levers (5).
CAUTION
Do not push down the kick starter with
the engine on.
N
Push down the kick starter (8) with your
right foot, releasing it immediately.
If necessary, repeat the operation until
the engine starts.
use and maintenance Habana 50/125 - Habana Custom 50/125
35