Figure 171 Nat Example 3; Figure 172 Example 3: Menu 11.3 - ZyXEL Communications P-793H User Manual

Figure 171 NAT Example 3

1 In this case you need to configure Address Mapping Set 1 from Menu 15.1 - Address
Mapping Sets. Therefore you must choose the Full Feature option from the Network
Address Translation field (in menu 4 or menu 11.3) in
2 Then enter 15 from the main menu.
3 Enter 1 to configure the Address Mapping Sets.
4 Enter 1 to begin configuring this new set. Enter a Set Name, choose the Edit Action and
then enter 1 for the Select Rule field. Press [ENTER] to confirm.
5 Select Type as One-to-One (direct mapping for packets going both ways), and enter the
local Start IP as 192.168.1.10 (the IP address of FTP Server 1), the global Start IP as
10.132.50.1 (our first IGA). (See
6 Repeat the previous step for rules 2 to 4 as outlined above.
7 When finished, menu 15.1.1 should look like as shown in

Figure 172 Example 3: Menu 11.3

IP Options:
IP Address Assignment = Dynamic
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= N/A
NAT= SUA Only
Metric= 2
Private= No
RIP Direction= None
Multicast= None
IP Policies=
The following figure shows how to configure the first rule.
Chapter 28 NAT Setup
Menu 11.3 - Remote Node Network Layer Options
Address Mapping Set= N/A
Version= RIP-1
Figure 172 on page
Figure 173 on page 294).
Bridge Options:
Ethernet Addr Timeout(min)= N/A
P-793H User's Guide
293.
Figure 174 on page 294.
293