No Security - ZyXEL Communications P-660HNT1 User Manual

Chapter 8 Wireless LAN
The following table describes the labels in this screen.
Table 26 Network > Wireless LAN > AP
LABEL
Wireless Setup
Enable
Wireless LAN
Channel
Selection
Common Setup
Network
Name (SSID)
Hide SSID
Security
Mode
MAC Filter
Edit
QoS
Apply
Cancel
Advanced
Setup

8.2.1 No Security

In the Network > Wireless LAN > AP screen, select No Security from the
Security Mode list to allow wireless devices to communicate with the ZyXEL
Device without any data encryption or authentication.
106
DESCRIPTION
Click the check box to activate wireless LAN.
Set the operating frequency/channel.
The SSID (Service Set IDentity) identifies the service set with which a
wireless device is associated. Wireless devices associating to the access
point (AP) must have the same SSID. Enter a descriptive name (up to 32
printable 7-bit ASCII characters) for the wireless LAN.
Note: If you are configuring the ZyXEL Device from a computer
connected to the wireless LAN and you change the ZyXEL
Device's SSID or WEP settings, you will lose your wireless
connection when you press Apply to confirm. You must then
change the wireless settings of your computer to match the
ZyXEL Device's new settings.
Select this check box to hide the SSID in the outgoing beacon frame so a
station cannot obtain the SSID through scanning using a site survey tool.
See the following sections for more details about this field.
This shows whether the wireless devices with the MAC addresses listed are
allowed or denied to access the ZyXEL Device using this SSID.
Click this to go to the MAC Filter screen to configure MAC filter settings.
See Section 8.2.6 on page 112
Select this check box to activate Quality of Service (QoS).
Click this to save your changes.
Click this to restore your previously saved settings.
Click this to display the Wireless Advanced Setup screen and edit more
details of your WLAN setup. See
details.
for more details.
Section 8.2.5 on page 110
P-660HN-TxA User's Guide
for more