ZyXEL Communications P-660HNT1 User Manual page 216

Chapter 20 Logs
For type and code details, see
Table 79 ICMP Logs
LOG MESSAGE
Firewall default policy: ICMP
<Packet Direction>, <type:%d>,
<code:%d>
Firewall rule [NOT] match: ICMP
<Packet Direction>, <rule:%d>,
<type:%d>, <code:%d>
Triangle route packet forwarded:
ICMP
Packet without a NAT table entry
blocked: ICMP
Unsupported/out-of-order ICMP:
ICMP
Router reply ICMP packet: ICMP
Table 80 CDR Logs
LOG MESSAGE
board %d line %d channel %d,
call %d, %s C01 Outgoing Call
dev=%x ch=%x %s
board %d line %d channel %d,
call %d, %s C02 OutCall
Connected %d %s
board %d line %d channel %d,
call %d, %s C02 Call
Terminated
Table 81 PPP Logs
LOG MESSAGE
ppp:LCP Starting
ppp:LCP Opening
ppp:CHAP Opening
ppp:IPCP
Starting
ppp:IPCP Opening
216
Table 87 on page 219.
DESCRIPTION
ICMP access matched the default policy and was
blocked or forwarded according to the user's
setting.
ICMP access matched (or didn't match) a firewall
rule (denoted by its number) and was blocked or
forwarded according to the rule.
The firewall allowed a triangle route session to
pass through.
The router blocked a packet that didn't have a
corresponding NAT table entry.
The firewall does not support this kind of ICMP
packets or the ICMP packets are out of order.
The router sent an ICMP reply packet to the
sender.
DESCRIPTION
The router received the setup requirements for a call.
"call" is the reference (count) number of the call.
"dev" is the device type (3 is for dial-up, 6 is for
PPPoE, 10 is for PPTP) "channel" or "ch" is the call
channel ID. For example,"board 0 line 0 channel 0,
call 3, C01 Outgoing Call dev=6 ch=0 "Means the
router has dialed to the PPPoE server 3 times.
The PPPoE, PPTP or dial-up call is connected.
The PPPoE, PPTP or dial-up call was disconnected.
DESCRIPTION
The PPP connection's Link Control Protocol stage has started.
The PPP connection's Link Control Protocol stage is opening.
The PPP connection's Challenge Handshake Authentication Protocol
stage is opening.
The PPP connection's Internet Protocol Control Protocol stage is
starting.
The PPP connection's Internet Protocol Control Protocol stage is
opening.
P-660HN-TxA User's Guide