Configuring The Switch - ZyXEL Communications MGS-3712 User Manual

Chapter 3 Hardware Overview
Table 2 LED Descriptions (continued)
LED
FDX
MGMT
10
100

3.4 Configuring the Switch

You may use the embedded web configurator or command line interface to configure the
Switch. If you're using the web configurator, you need Internet Explorer 5.5 and later or
Netscape Navigator 6 and later.
You can access the command line interface using a terminal emulation program on a computer
connected to the Switch console port (see
Telnet.
The next part of this guide discusses configuring the Switch using the web configurator.
48
COLOR STATUS DESCRIPTION
Amber On The Gigabit port is negotiating in full-duplex mode.
Blinking There is congestion in half-duplex mode.
Off The Gigabit port is negotiating in half-duplex mode.
Green Blinking The system is transmitting/receiving to/from an Ethernet device.
On The port is connected at 10Mbps.
Off The port is not connected at 10Mbps or to an Ethernet device.
Amber Blinking The system is transmitting/receiving to/from an Ethernet device.
On The port is connected at 100Mbps.
Off The port is not connected at 100Mbps or to an Ethernet device.
Section 3.1.1 on page 41) or access the Switch using
MGS-3712/MGS-3012F User's Guide