Status: Port Details - ZyXEL Communications MGS-3712 User Manual

Chapter 6 System Status and Port Statistics
Table 6 Status (continued)
LABEL
Link
State
LACP
TxPkts
RxPkts
Errors
Tx KB/s
Rx KB/s
Up Time
Clear Counter

6.2.1 Status: Port Details

Click a number in the Port column in the Status screen to display individual port statistics.
Use this screen to check status and detailed performance data about an individual port on the
Switch.
66
DESCRIPTION
This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps or 1000M
for 1000Mbps) and the duplex (F for full duplex or H for half). It also shows the cable
type (Copper or Fiber) for the combo ports.
If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the
port (see Section 11.1 on page 101
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it
displays STOP.
This fields displays whether LACP (Link Aggregation Control Protocol) has been
enabled on the port.
This field shows the number of transmitted frames on this port.
This field shows the number of received frames on this port.
This field shows the number of received errors on this port.
This field shows the number of kilobytes per second transmitted on this port.
This field shows the number of kilobytes per second received on this port.
This field shows the total amount of time in hours, minutes and seconds the port has
been up.
Enter a port number and then click Clear Counter to erase the recorded statistical
information for that port, or select Any to clear statistics for all ports.
for more information).
MGS-3712/MGS-3012F User's Guide