Figure 143 Management > Access Control > Snmp; Table 93 Management > Access Control > Snmp - ZyXEL Communications MGS-3712 User Manual

Chapter 29 Access Control
Figure 143 Management > Access Control > SNMP
The following table describes the labels in this screen.
Table 93 Management > Access Control > SNMP
LABEL
General Setting
Version
Get Community
Set Community
Trap Community
Trap Destination
Version
IP
244
DESCRIPTION
Use this section to specify the SNMP version and community (password) values.
Select the SNMP version for the Switch. The SNMP version on the Switch must
match the version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP
version 3 (v3) or both (v3v2c).
Note: SNMP version 2c is backwards compatible with SNMP
version 1.
Enter the Get Community string, which is the password for the incoming Get- and
GetNext- requests from the management station.
The Get Community string is only used by SNMP managers using SNMP version
2c or lower.
Enter the Set Community, which is the password for incoming Set- requests from
the management station.
The Set Community string is only used by SNMP managers using SNMP version
2c or lower.
Enter the Trap Community string, which is the password sent with each trap to
the SNMP manager.
The Trap Community string is only used by SNMP managers using SNMP
version 2c or lower.
Use this section to configure where to send SNMP traps from the Switch.
Specify the version of the SNMP trap messages.
Enter the IP addresses of up to four managers to send your SNMP traps to.
MGS-3712/MGS-3012F User's Guide