Introducing The Web Configurator; Web Configurator Overview; Accessing The G-570U Web Configurator - ZyXEL Communications G-570U User Manual

This chapter describes how to configure the G-570U using the Wizard.

3.1 Web Configurator Overview

The web configurator is an HTML-based management interface that allows easy G-570U
setup and management via Internet browser. Use Internet Explorer 6.0 and later or Netscape
Navigator 7.0 and later versions. The recommended screen resolution is 1024 by 768 pixels.
In order to use the web configurator you need to allow:
• Web browser pop-up windows from your device. Web pop-up blocking is enabled by
default in Windows XP SP (Service Pack) 2.
• JavaScripts (enabled by default).
• Java permissions (enabled by default).
See the Troubleshooting chapter if you want to make sure these functions are allowed in
Internet Explorer or Netscape Navigator.

3.2 Accessing the G-570U Web Configurator

Follow the steps below to access the web configurator, select a language, change your login
password and choose a configuration method from the status screen.
1 Make sure your G-570U hardware is properly connected (refer to the Quick Start Guide).
2 Prepare your computer/computer network to connect to the G-570U (refer to
2.2.1 on page 31
3 Launch your web browser.
4 Type the device name of your G-570U as the URL. ZyXELXXXX is the default where
"XXXX" is the last four digits of the MAC address. The MAC address is on the bottom
of the device). You could also use the IP address of the G-570U (192.168.1.2 is the
default). Press Enter.
Chapter 3 Introducing the Web Configurator
Introducing the Web
for instructions on how to do this).
ZyXEL G-570U User's Guide
C
H A P T E R
Configurator
3
Section
37