Wireless Client Mode - ZyXEL Communications G-570U User Manual

Table 11 Wireless Settings: Access Point (continued)
LABEL
Radio Enable
Data Rate
Management
Preamble Type
RTS/CTS
Threshold
Fragmentation
Apply
Reset

6.3.2 Wireless Client Mode

Select Wireless Client in the Operation Mode field to display the screen shown next. This
mode has the device act as wireless client to connect to a wireless network.
Note: WPA, WPA2 and IEEE 802.1x wireless security are not available when you use
Wireless Client, Bridge or AP+Repeater mode.
Chapter 6 Wireless Screens
DESCRIPTION
Turn on the wireless adapter to allow wireless communications between the device
and other wireless devices. Turn off the wireless adapter to stop wireless
communications between the device and other wireless devices.
Use this field to select a maximum data rate for the wireless connection(s). Please
note that this is a total rate to be shared by all of the device's wireless connections.
Preamble is used to signal that data is coming to the receiver. Short and Long
refer to the length of the synchronization field in a packet.
Short preamble increases performance as less time sending preamble means
more time for sending data. All IEEE 802.11b compliant wireless adapters support
long preamble, but not all support short preamble.
Select Long preamble if you are unsure what preamble mode the wireless
adapters support, and to provide more reliable communications in busy wireless
networks.
Select Dynamic to have the device automatically use short preamble when all
wireless clients support it, otherwise the device uses long preamble.
Note: The device and the wireless stations MUST use the same
preamble mode in order to communicate.
Enter a value between 0 and 2346. The default is 2346.
Enter a value between 256 and 2346. The default is 2346. It is the maximum data
fragment size that can be sent.
Click Apply to save your changes back to the device.
Click Reset to begin configuring this screen afresh.
ZyXEL G-570U User's Guide
63