ZyXEL Communications ES3500-24 User Manual page 315

Table 138 Management > Cluster Management > Configuration (continued)
LABEL
VID
Apply
Cancel
Clustering
Candidate
List
Password
Add
Cancel
Refresh
The next summary table shows the information for the clustering members configured.
Index
MacAddr
Name
Model
Remove
Cancel
ES3500-24 User's Guide
DESCRIPTION
This is the VLAN ID and is only applicable if the Switch is set to 802.1Q VLAN.
All switches must be directly connected and in the same VLAN group to belong
to the same cluster. Switches that are not in the same VLAN group are not
visible in the Clustering Candidates list. This field is ignored if the
Clustering Manager is using Port-based VLAN.
Click Apply to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the Save
link on the top navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
The following fields relate to the switches that are potential cluster members.
A list of suitable candidates found by auto-discovery is shown here. The
switches must be directly connected. Directly connected switches that are set
to be cluster managers will not be visible in the Clustering Candidate list.
Switches that are not in the same management VLAN group will not be visible
in the Clustering Candidate list.
Each cluster member's password is its web configurator password. Select a
member in the Clustering Candidate list and then enter its web configurator
password. If that switch administrator changes the web configurator password
afterwards, then it cannot be managed from the Cluster Manager. Its Status
is displayed as Error in the Cluster Management Status screen and a
warning icon ( ) appears in the member summary list below.
If multiple devices have the same password then hold [SHIFT] and click those
switches to select them. Then enter their common web configurator password.
Click Add to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on
the top navigation panel to save your changes to the non-volatile memory
when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Refresh to perform auto-discovery again to list potential cluster
members.
This is the index number of a cluster member switch.
This is the cluster member switch's hardware MAC address.
This is the cluster member switch's System Name.
This is the cluster member switch's model name.
Select this checkbox and then click the Remove button to remove a cluster
member switch from the cluster.
Click Cancel to begin configuring this screen afresh.
Chapter 41 Cluster Management
315