ZyXEL Communications ES3500-24 User Manual page 157

The following table describes the labels in this screen.
Table 45 Advanced Application > Port Authentication > MAC Authentication
LABEL
Active
Name Prefix
Password
Timeout
Port
*
Active
Apply
Cancel
ES3500-24 User's Guide
DESCRIPTION
Select this check box to permit MAC authentication on the Switch.
Note: You must first enable MAC authentication on the Switch before configuring it on each
port.
Type the prefix that is appended to all MAC addresses sent to the RADIUS server for
authentication. You can enter up to 32 printable ASCII characters.
If you leave this field blank, then only the MAC address of the client is forwarded to the
RADIUS server.
Type the password the Switch sends along with the MAC address of a client for
authentication with the RADIUS server. You can enter up to 32 printable ASCII characters.
Specify the amount of time before the Switch allows a client MAC address that fails
authentication to try and authenticate again. Maximum time is 3000 seconds.
When a client fails MAC authentication, its MAC address is learned by the MAC address
table with a status of denied. The timeout period you specify here is the time the MAC
address entry stays in the MAC address table until it is cleared. If you specify 0 for the
timeout value, then this entry will not be deleted from the MAC address table.
Note: If the Aging Time in the Switch Setup screen is set to a lower value, then it
supersedes this setting. See
This field displays a port number.
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select this checkbox to permit MAC authentication on this port. You must first allow MAC
authentication on the Switch before configuring it on each port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 18 Port Authentication
Section 8.5 on page 85.
157