Erasing All Of Your Programmed Settings (Vsx-D812/D912 Only); Clearing All The Remote Control Settings; Direct Function - Pioneer VSX-D712-S Operating Instructions Manual

10 Controlling the rest of your system
6 When you're done, press RECEIVER to
store the operation(s).
• Some commands from other remote
controls cannot be learned, but in most
cases the remotes just need to be moved
closer together or farther apart.
• Certain buttons represent operations that
cannot be learned from other remote
controls. These include: RECEIVER
MULTI CONTROL buttons, RECEIVER
CONTROL and MASTER VOLUME
buttons.
Erasing all of your
programmed settings
VSX-D812/D912 only
This erases all of the buttons you have
programmed (in Programming signals from
other remote controls, above) and restores the
button to the factory default.
• While pressing the RECEIVER button,
press and hold the 9 button for three
seconds.
The LED blinks steadily for three seconds and
then goes off.
Clearing all the remote
control settings
You can clear all presets and restore the
factory default settings.
• While pressing the RECEIVER button,
press and hold the 0 button for three
seconds.
The LED blinks three times indicating the
settings have been restored to the factory
presets.
60
En

Direct function

• Default setting: ON
You can use the direct function feature to
control one component using the remote
control while at the same time, using your
receiver to playback a different component.
This could let you, for example, use the
remote control to set up and listen to a CD on
the receiver and then use the remote control
to rewind a tape in your VCR while you
continue to listen to your CD player.
,the
When direct function is on, any component
you select (using the MULTI CONTROL
buttons ) will be selected by both the receiver
and the remote control. When you turn direct
function off, you can operate the remote
control without affecting the receiver.
1 While pressing the RECEIVER button,
press and hold the 4 button.
The LED blinks.
2 Press the MULTI CONTROL button for
the component you want to control.
The LED lights.
3 Use the number buttons to enter
either 1 (direct on) or 2 (direct off).
The LED blinks again.
4 Repeat steps 2 through 3 for the other
components you want to control.
5 When you're done, press RECEIVER.
• You can't use direct function for TUNER.