Connections; Remote Control - Aiwa CSD-MD5 Operating Instructions Manual

CONNECTIONS
REMOTE CONTROL
IMPORTANT
Be sure to connect the AM antenna first, then connect the
AC cord in the end.
~ Connect the supplied AM antenna to AM LOOP
ANT terminal.
z Connect the AC cord to an AC outlet.
L.
The display window demonstrates the functions of the
unit. (To set the current time, see SETTING THE
CLOCK on page 22.)
CAUTION
Use only the supplied AC cord. Use with other cords may
result in the risk of fire.
To stand the AM antenna on a surface
Fix the claw to the slot.
Inserting batteries
Detach the battery cover on the rear of the remote control
and insert two R6 (size AA) batteries.
o
When to replace the batteries
The maximum operational distance between the remote
control and the sensor on the main unit should be
approximately 5 meters (16 feet). When this distance
decreases, replace the batteries with new ones.
If the unit is not going to be used for an extended period of
time, remove the batteries to prevent possible electrolyte
leakage.
The remote control may not operate correctly when:
- The line of sight between the remote control and the unit
is exposed to intense light, such as direct sunlight
- Other remote controls are used nearby (television, etc.)
Do not disconnect the AC cord while the power is being
on. Otherwise, the data concerning the contents of the MD
recording may not be registered properly.
Do not bring the AM antenna near the AC cord since noise
will be picked up.
Do not unwind the AM antenna wire.
4
ENGLISH