Preparations; Connections - Aiwa AV-NW30, AV-NW31 Operating Instructions Manual

PREPARATIONS

CONNECTIONS

Before connecting the AC cord
The rated voltage of your unit shown on the rear panel is 120 V
AC. Check that the rated voltage matches your local voltage.
IMPORTANT
Plug in the AC power cord to the AC outlet after all other
connections are made.
DVD, video 2* 1 , LD*
to COAXIAL
DIGITAL OUT
Coaxial
connecting cord
to OPTICAL
DIGITAL OUT
DVD player
1
* When connecting a monaural video, use a stereo-mono
connecting cord (not supplied).
2
* When connecting an LD player equipped with the AC-3 RF OUT
terminal, use an RF demodulator unit. Also connect the analog
AUDIO OUT terminals of the LD player to the receiver to play
all the sources. For further information, refer to the instructions
of the LD player.
4
ENGLISH
2 or cable TV
Optical connecting cord
to OPTICAL DIGITAL OUT
to VIDEO OUT* 4
to AUDIO OUT
* 3
COAXIAL
(VIDEO 2)
3
*
OPTICAL
(VIDEO 1)
* 3
OPTICAL
(DVD)
DIGITAL IN
PCM
DVD
/ DOLBY DIGITAL
/ DTS
IN
VIDEO
Optical
connecting cord
L
AUDIO
R
IN
DVD
4
to VIDEO OUT*
to AUDIO OUT
CONNECTING EQUIPMENT
Jacks and plugs of the connecting cord are color-coded as follows:
Red jacks and plugs: For the rigtht channel of audio signals
White jacks and plugs: For the left channel of audio signals
Yellow jacks and plugs: For video signals
NOTE
Insert the plugs fully into the jacks. Loose connections may
produce a humming sound or other noise interference.
Video 1*
to VIDEO OUT (Video 1)
to AUDIO OUT
to VIDEO IN (Video 1)
to AUDIO IN
to VIDEO IN
to AUDIO OUT
VIDEO 2
VIDEO 1 / MD MONITOR
/ LD / TV
IN IN OUT VIDEO OUT
IN IN OUT OUT IN IN
VIDEO 2
VIDEO 1 / MD TAPE AUX
/ LD / TV
CD player
to LINE IN to LINE OUT
Tape deck
3
* Input sound through the DIGITAL IN terminals (COAXIAL
(VIDEO 2), OPTICAL (VIDEO 1) and OPTICAL (DVD)) cannot
be recorded. When recording the sound from the DVD, CD, MD
or LD player, connect the analog AUDIO OUT terminals of the
player to the corresponding AUDIO IN terminals of the receiver.
4
* With this connection, the picture noise may appear when playing
copy protected DVDs. In this case, it is recommended to connect
the VIDEO OUT terminal of the DVD player directly to a TV set,
not through the receiver.
1 or MD player
TV
REAR
IN
CD
to LINE OUT
Signal stream
u