Recordinga Whole Cd - Aiwa CSD-MD5 Operating Instructions Manual

RECORDING A WHOLE CD
STOP
2
1
2----rfjsiji?q&?q&
b
9000
0000
0000
0000
0000
0000
I
ail
00
I
CD~
Insert a recordable MD into the disc drive with
the label side up and in the direction of the
arrow.
Arrow
Load a CD and press CD M MD in stop mode.
CD * MD DIRECT is displayed and the recording
begins.
Remaining recordable time of the MD
Elapsed playing time of the CD
When the last track of the CD finishes playing, the recording
stops automatically.
When the recording finishes, TOC-EDIT flashes while the
data concerning the contents of the recording are registered.
The track order information in the original CD will be
copied as the index marks.
To stop recording
Press STOP. Recording stops and TOC data is
registered.
To stop playing the CD, press STOP again.
When pressing CD on the remote control, recording and
CD play stop simultaneously.
When pressing DISP in stop mode, the remaining
recordable time is displayed for 4 seconds.
To record on a previously recorded MD
If there is an unrecorded section left on the MD, the new
recording automatically starts from where the previous
recording finished.
If you want to start recording from the beginning of a
previous recorded MD, erase the previous recording
completely. (See page 21.)
T. OVER is displayed when:
The remaining recordable time of the MD is not enough to
record a whole CD.
Press STOP and replace the MD
with another one.
If it does not matter whether recording is cut short or not,
press CD F MD again to start recording.
Registering the index mark automatically
- When recording from a CD, the index mark information
recorded on the CD is copied as it is.
CD
2nd
3rd 4th
track track track
Recording (MD)
2nd
3rd 4th
track track track
A
A
A A
A : Index mark
- When recording from the radio, the index mark information
is registered every 5 minutes.
There may be a case where index marks are not registered
accurately.
14
ENGLISH