Netware Setting - Kyocera KM-C2525E Advanced Operation Manual

Printer Settings
15 Press [ ] or [ ] to select Subnet Mask and press [Change #].
16 Set the address in the same manner as Steps 12 - 14 to set the IP address.
17 Press [ ] or [ ] to select Gateway and press [Change #].
18 Set the address in the same manner as Steps 12 - 14 to set the IP address.
19 Press [Close]. The display returns to the Interface Configuration screen.
20 Press [Close]. The display is returned to the Printer menu screen.

NetWare Setting

To connect via the Netware protocol, set to [On] and set frame mode to [Auto], [802.3], [Ethernet II],
[802.2] or [802.3SNAP].
1 Refer to steps 1 - 4 of TCP/IP Settings on page 3-6 to display the Interface screen.
2 Press [ ] or [ ] to select NetWare and
press [Change #].
3 Press [On] or [Off].
4 Press [Close]. The display returns to the Interface screen.
5 Press [Close]. The display is returned to the Printer menu screen.
EtherTalk Setting
Set EtherTalk to [On] to connect this device to an Apple Macintosh computer.
1 Refer to steps 1 - 4 of TCP/IP Settings on page 3-6 to display the Interface screen.
2 Press [ ] or [ ] to select Ethertalk and
press [Change #].
3 Press [On] or [Off].
4 Press [Close]. The display returns to the Interface screen.
5 Press [Close]. The display is returned to the Printer menu screen.
3-8
Interface
Setting Item
NetWare On
TCP/IP On
Ethertalk On
Network Status Page Off
Parallel Network
Printer menu
Interface
Setting Item
NetWare On
TCP/IP On
Ethertalk On
Network Status Page Off
Parallel Network
Printer menu
Value
Change #
USB
Value
Change #
USB