Konica Minolta Magicolor 1650EN Reference Manual page 290

Item
Read/
Write
Account
SNMP
TRAPS
Configuring the Printer (Administrator Mode)
Description
User Name Specifies the reading/writing user name.
Range: Up to 32 characters
Default: restrict
Authentica- Specifies the reading/writing user authentication
tion password to be used for authentication.
Password Range: 8 to 32 characters
Default: <Mac address>(excluding colons)
Privacy Specifies the reading/writing user privacy password
Password to be used for privacy (encryption).
Range: 8 to 32 characters
Default: <Mac address>(excluding colons)
Security Specifies the security level for reading/writing user.
Level Choices: noAuthNoPriv, authNoPriv, AuthPriv
Default: AuthPriv
Enable Specifies whether or not to permit the Trap settings
Traps Choices: Enable, Disable
Default: Enable
Enable Specifies whether to enable or disable the Trap set-
Authentica- tings when authentication failed.
tion Choices: Enable, Disable
Failure Default: Disable
Traps
Trap Com- Specify the community name for the SNMP trap.
munity Range: Up to 15 characters
Name 1 Default: public
Trap IP Specify the IP address of the SNMP trap receiver.
Address 1 An IPv4 or IPv6 address or a FQDN can be speci-
fied.
Range: Up to 255 characters
Default: 0.0.0.0
Trap UDP Specify the port number of the SNMP trap.
Port Range: 1 - 65535
Number 1 Default: 162
Trap Com- Specify the community name for the SNMP trap.
munity Range: Up to 15 characters
Name 2 Default: public
The same name specified as the Discovery
user name cannot be used.
7-105