Led Indicators And The Print Button; Led Indicators - Intermec EasyCoder PD41 User Manual

LED indicators and the Print Button

The PD41 printer can enter the following different "states",
which in turn indicate its current mode of operation.
PD41 Printer States
State
Power Off
Upgrading
TestMode
Extended TestMode
PUP
Idle
Application running
Printing
Printing (wait for LTS)
Paused
Error

LED indicators

The four LED indicators will be turned on, off or flash
depending on which state the printer is in. The Power LED will
always be lit for all states except Power Off.
The blue Ready-to-Work LED shows the operational status of the
printer. In simple terms, it is lit when the printer is operational.
When the Ready-to-Work indicator is turned off, or flashes, it
indicates that the printer is not fully operational. There are a
number of conditions that can cause this behaviour; refer to
Chapter 4, "Troubleshooting" for a detailed explanation. It can
also flash when in Testmode or Extended Testmode, see
"Running Testmode" in Chapter 5.
The red Error LED will be lit or flash when an error condition
has occured. This will also cause the Ready-to-Work LED to flash
or turn off.
EasyCoder PD41 Printer User's Guide
Chapter 2 — Operating the Printer
Explanation
Firmware is being upgraded.
See Chapter 5 for description.
See Chapter 5 for description.
Power-UP (starting up)
Fingerprint only.
Waiting for Label Taken Sensor to indicate
that label has been taken.
Paused during print job
Error state
23